RB-MO Solvent based chemical release agent

APPLICATION FIELDS

RB-MO is formulated for application to plywood, timber, steel and plastic faced formwork and moulds, prior to casting concrete, to ensure a clean release.

FEATURES

RB-MO reacts chemically with cement to impart excellent release properties to treated Concrete cast against surfaces coated with RB-MO exhibit a smooth, hard, uniform finish.
RB-MO has no negative effect on the properties of concrete nor will it impair the adhesion of subsequent surface treatments when applied at the recommended coverage

PACKAGING

RB-MO is available in 220 kg drums and 20 kg gallons.

TECHNICAL SPECIFICATIONS

Physical state: Liquid

Color: cream

Chloride content: nil

Freezing point: -10°C

Flashpoint: 66°C

DIRECTION FOR USE

Apply before the first casting and thereafter re-apply immediately after stripping and cleaning the mould. Lightweight horticultural sprayers are ideal as RB-MO is finely atomized to give a uniform coating. Excessive application should be avoided. Alternatively, application may be made by a fine haired brush, only a very thin coating should be made and any excess removed.

If after the first application, the RB-MO is completely absorbed into new timber or plywood, a further application should be made before filling the moulds or formwork.

The coverage rate for RB-MO is 30 to 70m²/liter when spray applied depending on smoothness and porosity of the formwork used.

Note:

Progressively better results are obtained on plywood and timber moulds as they become impregnated and the operatives become accustomed to working with the release agent. RB-MO in general, may be used over timber moulds. etc., which have been treated with other mould oils, providing excess has been removed.

STORAGE

Store under cover, out of direct sunlight and protect from extremes of temperature. Storage life is 6 mouth when stored in unopened containers.

SAFETY

As with all chemical products care should be taken during use and storage to avoid contact with eyes mouth skin and foodstuffs (which can also be tainted with vapor until product fully cured or dried). Treat splashes to eyes and skin immediately. If accidentally ingested, seek immediate medical attention. Reseal containers after use.

Reviews

There are no reviews yet.

Be the first to review “RB-MO Solvent based chemical release agent”

RB-MO Solvent based chemical release agent

APPLICATION FIELDS

FEATURES

PACKAGING

TECHNICAL SPECIFICATIONS

DIRECTION FOR USE

STORAGE

SAFETY

Reviews

Related products

MICROCEMENT RB-MICROCEMENT

RB-MW Water dispersible chemical release agent

RB-IV 52T ALL PURPOSE INVISIBLE SILOXANE TRANSPARENT

RB-EPP 151 TWO COMPONENTS EPOXY ZINC RICH PRIMER

RB-ECT 2K COAL TAR EPOXY, TWO COMPONENTS

RB-CUR 765 Polymer based curing for concrete

RB-CUR 9 WATER-BASED CURING COMPOUND

RB-BP PRIMER COATING BASED ON BITUMEN

BITUMER W800 High solids protective coating based on emulsified bitumen

Epofloor G EPOXY FLOOR COATING